Voltage Selector Switch; Operating Instructions - Schumacher Electric SE-40MAP Guide D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Engine Start
weak or run down battery. Always use in combination with a battery.

Voltage Selector switch

Use this switch to set the charger to charge a 6 volt, 12 volt or 24 volt bat-
tery.
NOTE: These chargers are not recommended for 8 or 16 volt systems.
LED Indicators
Full Charge
charged and the charger has stopped charging and switched to the Main-
tain Mode of operation (Automatic Mode Only).
Power On
to the battery charger.
Check Battery
with the battery. Check the DC connections for an improper connection;
otherwise the battery may be bad.
11.

OPERATING INSTRUCTIONS

Overview
1.
Connect the battery following the precautions listed in Sections 6 and
7.
2.
Select the appropriate settings for your battery.
3.
Connect the AC power following the precautions listed in Section 8.
Charging
Indication of a Fully Charged Battery:
A hydrometer reading of the specific gravity of the electrolyte (fluid) of a
battery in good condition should be between 1.250 and 1.285. When a
battery reaches 80 to 85% of a full charge, bubbles will appear on the
surface of the fluid. As the battery nears full charge, the bubbling will
become more active. At no time during the charge cycle should there be
any sign of vigorous bubbling of the battery fluid.
There are some important facts to keep in mind when charging a
battery.
ɶ
enough to start most vehicles.
ɶ
the battery compared to the charge it should have if the charging
process is allowed to complete and can be used to estimate the
relative charge time. The lower the charge % shown the longer the
charge time for a given battery.
ɶ
the charging process. The higher the charge % displayed, the less
charge time remains.
– Provides additional amps for cranking an engine with a
– When lit, this LED indicates that the battery is fully
– When lit, this LED indicates that there is AC power supplied
– When lit, this LED indicates there is something wrong
When the battery reaches 77% charged, it has been charged
The charge % shown is an estimate of the relative charge in
The charge % shown is an indication of the relative progress of
9

Publicité

Table des Matières
loading

Table des Matières