Changing The Standard Plate (Only For Kd-Sc800) - JVC KD-SC800 Manuel D'instructions

Changing the standard plate
This section is only for KD-SC800.
You can change the standard plate with another
plate supplied with your unit.
You can also download them by visiting
<http://www.jvc.co.jp/jvccar>.
• When changing the plate, be careful not to
leave your fingerprints on the plate or cover.
1
Loosen the screws with the supplied
hex screwdriver.
2
Remove the plate cover and the
standard plate.
Standard
plate
3
Replace with another plate (a
standard, cutout, or downloaded
plate) of your preference.
• When attaching a standard plate
Standard
plate
22
Notes:
• Be sure to keep the hex screwdriver for future use.
• Two spare screws for the plate cover attachment are
• When you attach the plate cover, do not tighten the
Plate cover
Plate cover
• When attaching a cutout or downloaded
plate
Add the transparent plate (supplied)
between the cutout or downloaded plate
and the plate cover in order to attach the
plate cover in place.
Cutout or
downloaded plate
Plate cover
provided with the unit. (See the Installation/
Connection Manual.)
screws too hard; otherwise, the plate cover might be
cracked.
How to use the cutout plates
1
Unfold the supplied cutout plates.
2
Cut the plates out using a scissors.
3
Trim out the window and two knobs using a
knife on a rubber mat.
Transparent plate
(supplied)