Complete The Installation; Water Filtration System - Amana ASI2575GRW Instructions D'installation

Complete the Installation

WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
1. Plug into a grounded 3 prong outlet.
2. Flush the water system. See "Water and Ice Dispensers" in
the User Instructions or User Guide.
NOTE: Allow 24 hours to produce the first batch of ice. Allow
72 hours to completely fill the ice container.

Water Filtration System

Do not use with water that is microbiologically unsafe or
of unknown quality without adequate disinfection before
or after the system. Systems certified for cyst reduction
may be used on disinfected waters that may contain
filterable cysts.
Water Filter Status Light (on some models)
The filter status light will help you know when to change your
water filter. This is located in the refrigerator control panel.
The light will turn red. This tells you that it is time to change
■
the filter.
It is recommended that you replace the filter when the status
■
light turns red or water flow to your water dispenser or ice
maker decreases noticeably.
NOTE: The filter should be replaced at least every 6 months
depending on your water quality and usage.
Resetting the Filter Status
The rest button is located on the control panel in the
■
refrigerator compartment. To reset the status light after
changing the filter, press TEMP SETTING within 3 seconds.
The status light will change from red to off when the system
is reset.
Changing the Water Filter
Style 1
A. Water filter cover door
10
A
1. Locate the water filter cover door in the base grille, and pull
open the filter door. The filter will be released and then be
ejected as the door is opened.
2. When the door is completely open, pull the filter straight out.
NOTE: There may be some water in the filter. Some spilling
may occur. Use a towel to wipe up any spills.
3. Take the new filter out of its packaging and remove the
covers from the O-rings. Be sure the O-rings are still in place
after the covers are removed.
4. With the arrow pointing to the left (toward the filter cover
door's hinge), align the new filter with the filter housing and
slide into place. The filter cover door will automatically begin
to close as the new filter is inserted.
5. Close the filter cover door completely in order to snap the
filter into place. You may need to press hard.
6. Flush the water system. See "Water and Ice Dispensers" in
the User Instructions or User Guide.
Style 2
1. Locate the water filter cover door in the base grille, and pull
open the filter door.
A. Water filter cover door
2. Twist the water filter and turn 90° counterclockwise to unlock.
3. Pull the filter out of the housing.
4. Remove the water filter cap from the water filter.
A