Figure 21
5.
To unfold the handle, refer to
Handle (page
10).
Storing the Machine in the
Vertical-Stow Position
You can store your machine in the vertical position to
minimize storage space.
WARNING
Folding or unfolding the handle improperly
can damage the cables, causing an unsafe
operating condition.
• Do not damage the cables when folding or
unfolding the handle.
• If a cable is damaged, contact an
Authorized Service Dealer.
1.
Remove the electric-start button and battery
from the machine.
2.
Ensure that the cutting-height setting on the
machine is 92 mm (3-5/8 inches) or lower; if it is
not, lower it; refer to
(page
15).
3.
Disengage the handle locks
2 Unfolding the
Adjusting the Cutting Height
(Figure
22).
4.
Fold the handle fully forward.
Important:
of the handle knobs as you fold the handle.
5.
Engage the handle locks.
6.
Lift the front of the machine by the handle and
move it into a storage space
g251299
22
Figure 22
Route the cables to the outside
(Figure
Figure 23
g251585
23).
g251586