High Pressure Connection; Connection To The W Ater Supply - Interpump T Serie Mode D'emploi

5.1 HIGH PRESSURE CONNECTION

1 - Connect one end of the high pr essure hose to the automatic gun (A) and the other end to
the OUTLET connection on the machine. Tighten firmly (B).
2 - Complete the assembly by coupling the extension to the gun/lance and tighten firmly (C).

5.2 - CONNECTION TO THE W ATER SUPPLY

1- The maximum temperature of the inlet water must not exceed 60°C (140°F).
2. WARNING: You can connect the machine INLET (D) fitting to the mains water supply
only by installing:
• an approved check valve in compliance with IEC EN 61770 on the mains water supply outlet.
• and using a hose with inside diameter of at least 13 mm. (1/2") in compliance with IEC
EN 61770.
3- Since the water flow decr eases according to the length of the hose, make sur e that the quan-
tity of water supplied to the machine is not less than the quantities indicated in the chart below .
4- The pressure of the inlet water must not exceed 10 bar , 1 MPa, 145 psi.
ATTENTION: The water supply which enters into the washer is not drinkable.
FLOW RATE OF
T-TX SERIES
WATER SUPPLY
MODEL L/min.
11
T 8-90
13
TX 955.6
T 10-100
T 11-120
TX 10-130
15
TX 12-100
TX 12-140
TX 951
TX 14-120
TX 13-180
17
TX 956
TX 954
TX 15-150
TX 17-130
20
TX 957
TX 961
If the user wishes to power the washer by means of free suction, simply emerge the end of the
supply tube in the water to be suctioned. The maximum suction depth consider ed as the dis-
tance in height between the water surface and the pump varies between 1 m. and 3 m. (see
technical specifications table).
IMPORTANT
The water supplied to the machine must be clean. Running the unit without water , or with water
which is dirty, contains grit or corrosive liquids, causes serious damage to the machine.
All manuals and user guides at all-guides.com
G.P .M. USA
2.9
3.4
4
4.5
5.3
13