High Pressure Connection; Connection To The Water Supply - Interpump IPX Série Mode D'emploi

5.1 HIGH PRESSURE CONNECTION

1 - Connect one end of the high pressure hose to the end of the automatic gun (A) and the other
end to the OUTLET connection on the machine. Tighten firmly (B).
2 - Complete the assembly by coupling the extension to the gun/lance and tighten firmly (C).

5.2 - CONNECTION TO THE WATER SUPPLY

1- The maximum temperature of the inlet water must not exceed 60°C (140°F).
2. WARNING: You can connect the machine INLET (D) fitting to the mains water supply
only by installing:
• an approved check valve in compliance with IEC EN 61770 on the mains water supply outlet.
• and using a hose with inside diameter of at least 13 mm. (1/2") in compliance with IEC
EN 61770.
3- Since the water flow decreases according to the length of the hose, make sure that the quan-
tity of water supplied to the machine is not less than the quantities indicated in the chart below.
4- The pressure of the inlet water must not exceed 10 bar / 1 MPa / 145 PSI.
ATTENTION: The water supply which enters into the washer is not drinkable.
FLOW RATE OF
IP SERIES
WATER SUPPLY
MODEL L/min.
IP130 11
IP140 11
IP150 13
IP170 17
FLOW RATE OF
IPX SERIES
WATER SUPPLY
MODEL L/min.
IPX 10-130
IPX12-100
15
IPX 12-140
IPX 951
IPX 14-120
17
IPX13-180
IPX 954- 956
IPX 15-150
20
IPX17-130
IPX 957- 961
If the user wishes to power the washer by means of free suction, simply emerge the end of the
supply tube in the water to be suctioned. The maximum suction depth considered as the dis-
tance in height between the water surface and the pump varies between 0,5 m. and 3 m. (see
technical specifications table).
IMPORTANT
The water supplied to the machine must be clean. Running the unit without water, or with water
which is dirty, contains grit or corrosive liquids, causes serious damage to the machine.
G.P .M. USA
2,9
2,9
3,4
4,5
OUTLET
G.P .M. USA
4
4.5
5.3
B
OUTLET
INLET
B
INLET
13
C
A
D
ø 13 mm.
C
A
D
ø 13 mm.