Whirlpool WFG505M0BW Instructions D'installation page 15

To Convert Gas Pressure Regulator
1. Open broiler door and remove broiler rack. The gas pressure
regulator is located in the back right hand corner of the broiler
compartment.
A
A. Gas pressure regulator
IMPORTANT: Do not remove the gas pressure regulator.
NOTE: Do not remove the spring beneath the cap.
2. Remove the cap from the gas pressure regulator using a
flat-blade screwdriver.
NOTE: Make sure sealing washer remains in the same
position.
A. Cap
3. To convert to Natural gas, unscrew the plastic adjustment
screw by hand, turn it over, and screw it in again.
Inlet pressure
to LP gas
180º
A. Cap
B. Sealing washer
C. Adjustment screw
4. Reinstall the cap.
A
Inlet pressure
to Natural gas
A
B
C
To Convert Surface Burners
1. Remove burner grate, burner caps and burners.
A
B
A. Burner cap
B. Burner
C. Center burner
2. Locate the Natural gas orifice spuds for top burners in the
bag containing literature included with the range. Two Natural
gas spuds are stamped "194 (Black/White)," one is stamped
"155 (Red/Brown)," one is stamped "140 (Red/White)" and
one is stamped "110 (Red/Brass)."
3. Remove the LP gas orifice spuds using a 7 mm (⁹⁄₃₂")
combination wrench.
4. Install the Natural gas orifice spuds using a 7 mm (⁹⁄₃₂")
combination wrench.
A. Spud
B. Holder
C
A
B
15