Parts & Features; How To Use; How To Assemble - Hamilton Beach 840083100 Manuel

840083100 EN v03 3/2/01 3:14 PM Page 4
Parts & Features
1. Food Chute
2. Cover
3. S-Blade
4. Control Panel
5. Food Pusher
6. Food Gate
7. Continuous Feed
Chute
8. Reversible
Slicer/Shredder
9. Slinging Disc
10. Disc Shaft
11. Bowl
12. Center Column
4
How to Operate the Controls
ON-OFF-PULSE Switch: This is a three-position switch that
gives you a choice of "ON," "OFF," or "PULSE." Selecting the
ON position causes the motor to run continuously until you
move the switch to OFF. The PULSE position will cause the
motor to run only until you release the switch; then it auto-
matically springs back to the OFF position.

How to Use

How to Assemble

Always lock bowl on base before putting blade or disc in
position. Make sure blade or disc is securely in place before
using.
1. Make sure unit is off and unplugged.
2. Place bowl onto base. Align
tabs on bowl with slots on
base, as shown. Rotate the
bowl clockwise until it locks
into place.
3. Insert desired blade. Handle
carefully; blades are sharp.
S-Blade: Place the S-blade
onto center column of food
processor in center of bowl.
Slicer/Shredder Disc: Place the disc shaft onto center
column of food processor. Place reversible slicer/shredder
disc onto shaft, desired cutting edge up.
Tab
5