Battery Installation; Settings - weewell WTN520 Mode D'emploi

All manuals and user guides at all-guides.com
you hear two short beeps and either °C or °F appears.
3. Aim the Probe toward the forehead or object approximately 5cm
from surface, then press and release the POWER button to record
the measurement.
4. Read the temperature on the display.

BATTERY INSTALLATION

ATTENTION!
1. Use only same type of alkaline batteries to avoid incompatibility.
2. Replace with 2 new AAA batteries at the same time when the low battery
indicator appears.
3. The memories will be erased after replacing the batteries.
4. Remove the batteries if the device is not likely to be used for a long period
of time.
5. Do not dispose battery in a fire. The battery may explode.
1. Remove the battery cover to insert batteries.
2. Confirm the polarity (+ and -) of batteries is correct as indicated
inside the compartment and insert batteries accordingly.
3. Replace the battery cover.

SETTINGS

Changing Modes/Settings
The device has four modes/settings: 1. Forehead mode 2. Object tem-
perature mode 3. Beeper On/Off setting 4. Offset setting
The default mode is Forehead mode.
1. Press and release the POWER Button to turn on device.
2. Press and hold the Memory/Mode button firmly for about 3
seconds.
3. Continue to press and release the Memory/Mode Button to
switch between the four modes/settings.
WTN520 USER MANUAL I 5