Cequent Performance Products 24933 Instructions D'installation page 4

1. Lower exhaust system at the rubber isolator. Spraying a lubricant on
the metal hanger rod and the rubber isolator helps removal. Support
exhaust to prevent damage.
3. Place 3/8 flat washer onto stud on end panel (4) places.
©2017 Horizon Global Americas, Inc. -
Printed in Mexico
2. Remove the four lower M10 bumper nuts. There are 2 on the passenger side
and 2 on the driver side.
4. Raise hitch into position, using the 4 weld studs. Install the four M10
nuts removed in step 3 finger tight.
Sheet 4 of 15 24933NP 8-7-17 Rev. C