I Disassembling The Camera; I Connections - Panasonic WV-CF284 Serie Mode D'emploi

I Disassembling the Camera

1. Remove the top cover.
• Adjust the marker of this unit to "INSERT"
of the "DOME COVER" label on the top
cover and turn the top cover counter-
clockwise to remove it.
• The clear dome cover and the inner
dome cover are joined into a single unit.
Therefore, never try to remove them.
G To mount the camera directly on
the wall/ceiling
1. Prepare the mounting space.
2. Place the camera on the wall/ceiling and
The mounting requirements are shown as follows.
Mounting place
Ceiling/wall

I Connections

G Video output connection
Connect the video output connector to the
monitor or other system devices with the
procured coaxial cable or LAN cable.
The maximum extensible cable length is
shown in the table.
12
Model
(direct mounting)
mark four screw positions with a pen.
3. Mount the camera on the wall/ceiling
with 4 screws (procured locally).
4. Fasten all the mounting screws.
Camera mounting screw x4
(not supplied)
G To mount the camera on a two-
gang junction box
1. Install the two-gang junction box on the
wall/ceiling.
2. Mount the camera on the two-gang junc-
tion box with 4 screws (procured local-
ly).
3. Fasten all the mounting screws.
Recommended Number of
screw screws
M4 4 pcs.
Video output connector
46 mm {1-13/16"}
83.5 mm
{3-5/16"}
Minimum pull-
out strength
196 N {20 kgf}
Power cable
TOP
LOCK
<WV-CF284>