hestan KVL Serie Manuel D'installation, D'utilisation Et D'entretien page 18

INSTALLATION
8. This step will require the fasteners and hardware in the trim kit.
a) The liner must be lifted into place while guiding the wires into place and aligning the
EN
duct(s) or elbow(s) with the exhaust collar(s) or transition.
b) The duct(s) must fit inside the exhaust collar(s).
c) The lower edge of the liner should be flush with the enclosure or slightly above.
9. Install a wood screw with countersunk washer and flat washer into each mounting hole along
the bottom edge of the liner.
10. Trim Installation:
a) Install the trim piece for the back side of the
liner by hooking one side under the bottom
edges of the back countersunk washers.
b) Snap the trim piece over the top of the
countersunk washers by applying pressure
upward and toward the liner wall.
c) Repeat this process for the front trim piece.
d) After the back and front trim pieces are
installed, use the same process for the side
trim pieces.
• A rubber mallet may be used to gently tap the trim pieces into place if needed.
11. WIRING CONNECTION:
a) Bring wires into each of the connection boxes and secure them with the electrical wire
clamps.
b) From inside the liner, using UL listed wire nuts, attach the "neutral" wire(s) to the white
lead(s), the "hot" wire(s) to the black lead(s), and the ground wire(s) to the green lead(s)
inside the motor box(es).
12. For each removed blower motor: Re-plug its connector to the hood wiring, then reinstall the
blower motor using the three retaining screws that were previously removed.
• Make sure motors are installed in the correct locations. See "MOTOR IDENTIFICATION AND
POSITIONING" on page 9.
13. Make sure that the damper(s) open and close smoothly. Replace the blower housing(s) and the
blower shield(s).
14. Turn Power On, Verify Operation: See "USING THE VENTILATION SYSTEM" on page 5
for proper hood operation. Test all blower and light functions to ensure they are operating
properly.
14
©2020 Hestan Commercial Corporation
(CONT.)
DO NOT OPERATE HOOD WITHOUT A PROPER GROUND
CONNECTION.
Liner Trim Kit
Flat nylon washer
Wood screw
Trim piece
Countersunk
nylon washer