hestan KVL Serie Manuel D'installation, D'utilisation Et D'entretien page 11

CLEANING AND MAINTENANCE
CLEANING CLEANING
Clean the shield(s) and/or blower housing(s) in a sink of warm soapy water (liquid dish detergent)
and let soak for a few minutes. Wash with a sponge or dishcloth, rinse and let drain before
reinstalling. Alternatively, the blower housing(s) and blower shield(s) may be placed into a
dishwasher.
1
Item # Description
1 Motor housing
2 Wheel
3 Blower housing with damper(s)
4
Blower shield
Regular cleaning of the blower housing should prevent grease accumulation on the blower wheel.
If grease build-up should occur, the blower wheel may easily be cleaned in place using a soft bristle
toothbrush and a common degreaser such as Formula 409®.
Item # Description
1 Balancing clip
2
Blower wheel
2
To reduce the risk of personal injury, be sure the power is turned off in
the hood before removing the shield(s) and blower housing(s).
Take care not to move or lose the metal balancing clips that may be
affixed to the wheel.
1
(CONT.)
3
4
2
©2020 Hestan Commercial Corporation
EN
7