Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2.
Remove the baffle filters and spacers. If necessary, arrange the electrical wires to run
through the 1" diameter hole on the top or the rear of the hood. Refer to Figure 5.
3.
Using references on Table 1 and measurements on page 20 center the hood in place
beneath the cabinet and flush with the front of the cabinet.
4.
Draw electrical wires through cabinet access opening.
5.
Place screw (not provided) into the exact center of each knockout hole. Make sure all
screws are in place before tightening screws. CAUTION: MAKE SURE THE HOOD IS
SECURE BEFORE RELEASING.
Ductwork Installation
6.
Use aluminum or steel pipe to connect the plastic exhaust on the hood to the ductwork
above. Use duct tape to make all joints secure and air tight.
7.
Continued at "Wiring to Power Supply" on page 16.
Figure 4
9
1" Diameter
Hole
Figure 5
Publicité
Chapitres
Table des Matières
Dépannage
