Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Tools and Parts
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Tools needed
Pliers
Phillips screwdriver
Flat-blade screwdriver
³⁄₁₆" and ¼" (0.4 cm and
0.6 cm) nut drivers or hex
sockets
Measuring tape or ruler
1½" (3.81 cm) hole saw
bit
Parts needed
A
A. 72" (182.9 cm) flexible water supply line
B. Zip tie
C. 2 appropriate sized UL listed wire connectors
D. Handle (if installing custom front panels)
E. Overlay panel (if installing custom front panels)
†®TORX is a registered trademark of Acument Intellectual Properties, LLC
4
All manuals and user guides at all-guides.com
INSTALLATION REQUIREMENTS
10" (25.4 cm) adjustable
wrench
Utility knife
Level
Cordless drill
¹⁄₈" drill bit
Security T-20 TORX
driver (if installing custom
front panels)
D
E
Parts Supplied
Check that all parts are included.
A
E
®†
B
C
M
A. ³⁄₄ " (1.9 cm) UL listed strain
relief
B. 1.25" (3.1 cm) hose clamp
C. 8 mounting bracket screws
D. 4 unit mounting screws
E. Drain hose connector
F. 4 mounting brackets
G. Drain connector spring
clamps
IMPORTANT: Observe all governing codes and ordinances.
Failure to meet codes and ordinances could lead to fire or
electrical shock.
Proper installation is your responsibility.
Contact a qualified installer to ensure that the dishwasher is
installed to meet all electrical and plumbing national and local
codes and ordinances.
Install the dishwasher as specified in these instructions.
Have everything you need to properly install dishwasher.
Keep the dishwasher and water lines leading to dishwasher
from freezing. Damage from freezing is not covered by the
warranty.
This dishwasher is manufactured for indoor use only.
Install and level dishwasher on a floor that will hold the weight,
and in an area suitable for its size and use.
B
I
G
K
N
H. 2 trim strips
I. Toe kick brackets
J. 2 toe kick bracket screws
K. Toe kick trim
L. 2 panel fasteners (on some
models)
M. 10 TORX
models)
N. Drain hose
Location Requirements
C
D
F
H
J
L
®†
screws (on some
Publicité
Table des Matières
