Installing The Seat In The Car - JANE Matrix Light Mode D'emploi

2

Installing the seat in the car

Reclining position, GROUP 0
In the reclining position, MATRIX LIGHT must be fitted cross-wise on
the back seats. Decide on which seats after reading the section on
"Choosing where to install the safety seat".
Fasten the two straps you have chosen, the fasteners are on the
2a -
abdominal part of the belt, this area is marked in light blue in
the diagrams.
2b -
Open the fastener of the belt by turning the lock
2c -
Insert the abdominal part of the belt into the fastener and close
the fastener again.
2d - Lastly, tighten both belts.
2e -
To take the TRANSPORTER seat out of the vehicle, open the faste-
ner of the belt by turning the lock and take the seat belt off.
If you observe that the car seat belts are not long enough, you can adjust the following parameters to improve this:
- Recline the backrest of the car seat a little.
- Move the car seat back.
Posición sentada, GRUPO 0+
The MATRIX LIGHT safety seat must be installed FACING AWAY FROM
THE DIRECTION OF TRAVELLING. Decide on which seat after reading
the section on "Choosing where to install the safety seat".
2f -
Fasten the 3-point belt.
2g -
Position the safety seat on the seat of the vehicle. Put the handle
in the AUTO position, the position furthest forward.
2h -
Pass the abdominal part of the car seat belt through the two front
guides situated on the sides of the frame.
The shoulder belt of the car should be passed behind the safety
2i -
seat.
Tighten this part of the belt and fasten the locking clip. Make sure
2j -
that the seat is firmly fastened by pulling it.
- Adjust the shoulder height regulator of the car seat belts to
the lowest position.
25