Linea 2000 DOMO DO419BL Mode D'emploi page 17

KNOW YOUR BLENDER
1. Measuring cup
2. Spout
3. Glass jug
4. Motor unit
5. Working indicator
6. Top lid
7. Handle
8. Speed selector
FOR THE INITIAL USE
1. Unpack the appliance and place all parts on a horizontal surface.
2. Immerse jug, top lid measuring cup in warm soapy water and rinse them and dry.
Never immerse motor unit in water for cleaning to prevent the risk of electric shock.
Caution: the blade is very sharp, handle with great care.
3. The correct assembly way will be described in detail in below sections.
Before assembling the jug, be sure the power cord is unplugged from the power
outlet and the speed selector is on the 0 position.
the jug is suitable for making mixture which the juice and pulp are mixed.
4. Place the jug into the motor unit. Note: make sure the jug is assembled into the
motor unit properly If the jug is not assembled properly, the blender will not operate.
BLENDING FRUIT AND VEGETABLE:
1. Before attaching the power cord into the outlet, make sure the speed selector is in
the 0 position.
2. Peeled or cored the fruit or vegetables and then cut it into small dices, put the
food piece into the jug. Usually certain amount of purified water has to be added to
facilitate the smooth running of appliance. The proportion of the food and water is 2:3.
The amount of mixture should not exceed the max level as indicated on the jug.
Note: never use boiling liquids or run the appliance empty.
3. Replace the top lid on the jug. Only directly place the top lid into the jug.
4. Turn the speed selector to the desired setting, there are four setting: P, 0, 1, 2. The 1
setting is the low speed, the 2 setting is the high speed. Turn switch to P position and
hold it to pulse actuate motor for delicate chopping. Release it to return the 0 position.
5. You may add ingredient into the jug through the center opening of top lid during
operation, then replace Measuring Cup if necessary. Let the tab of Measuring Cup
aligns with the groove of top lid, put down and turn clockwise until it is locked.
6. The consecutive operation time shall not exceed 3 minutes. Minimum 1 minutes
rest period is required between two consecutive cycles.
1
2
3
4
17
DO419BL
5
6
7