Paradigm Garden Oasis GO4 Manuel De L'utilisateur page 11

5 . Thread the speaker
wire through the
center hole and
out of the wire
opening on the
surface mount
base . Place surface
mount base flush
against the surface
you wish to install
your speaker . To
attach surface
mount base to
the surface, use
appropriate screws
(not supplied) for
your installation .
For specifications
on screws, see your
dealer for details.
Note: For a wall mounted installation where a wire
connection is contained within the surface mount base,
please follow these instructions. It is recommend that the
speaker wire be cut short and the wire sleeve should be
removed to expose the red (+) and black (-) wires. Follow
steps 6 a-b, but do not attach the assembled speaker with
surface mount base until your wire connections are made
with silicone-filled wire connectors covering the exposed
wire connections. The wire connections with silicone-
filled wire connectors must be stuffed inside the surface
mount base before attaching to the desired surface with
appropriate screws (not supplied) for your installation. For
specifications on screws, see your dealer for details.
6 . To attach the
a)
speaker to the
surface mount
base: a) First
hand thread the
twist cap to the
surface mount
base . b) Now
firmly tighten the
twist cap with the
provided wrench .
b)
For wiring instructions see 'Speaker &
Burial Cable Connections' on page 11 .
EN |
10