Function Test And Settings - RIKA DOMO BACK MULTIAIR Instructions De Montage

Run the cable between the supply air duct and the conveyor trough
back to the green marked vertical cable duct�
In the bottom cable channel are the three pin connector M3 for the
upper convection fan 1 and the plug M4 for the lower convection fan
2� Insert the correct cable and put all cables and plugs back into the
cable channel�
Loosen the nut and the ring from the capacitor till the end from the
thread�
Attach the condenser (with 2 blowers both capacitors) in the free
slots�
Install the rear wall of the stove� It is mandatory to attach the motor
cover on the rear wall�
#13
Note
Operation without a motor cover and without air duct is not allowed
for security reasons� Disregard voids your warranty and no liability
is accepted for damage�

Function test and settings

Connect the power cord back in and select the Setup menu /
submenu Service. Perform a relais test to check the correct function
#13
of the Multi Air fan�
Select the Setup menu /submenu MULTIAIR fan. Switch the
MULTIAIR 1 to ON and you will get access to fan speed and fan
adaptation�
Fan level
The volume of convection air is adjustable from AUTO (adapts
automatically according to heating power), over to Level 1 (min) and
level 5 (max)�
Fan area
In addition, it is possible to adapt the Multi Air fan speed (AUTO, level
1 to level 5) within +/- 30% of fan speed�
#25
|25
24