General Information; Disassembly Rear Panels - RIKA DOMO BACK MULTIAIR Instructions De Montage

General information

Note the regional specific fire safety regulations and clarify the
Q
connection situation with the competent authority�
The convection air amount and temperature is designed for
Q
heating one or, if two fans are installed, two additional rooms�
The max� temperature of the convection air is 180° C at the air
Q
outlet�
The convection air duct should be as short as possible�
Q
Keep the number of deflections as small as possible�
Q
Note
Please pay attention to the national and country-specific building
and fire regulations when connecting the convection air pipes�
Installation and assembly must be performed by a trained
specialist only�
The option MULTIAIR is basically only with the lower flue pipe
connections (rear and side) possible� If only one convection fan is
mounted, it can be combined with the increased rear connection�
Note
Only work on the unit when the mains plug has been disconnected
and the stove has cooled down completely�
Note
During assembly / dismantling do not allow objects (screws etc�) to
fall into the pellet container – they can block the screw conveyor
and damage the stove�
Note
During any conversion work, take particular care of your fingers
and any panels and stove attachments� Select soft bases to
prevent scratches to your living space furniture and stove panels�

Disassembly rear panels

Remove the handle of the flue gas flap�
Loosen the 4 screws on the rear panel� The rear panel tilts backwards,
then you can lift it off�
#5
#3
#25
|23
22