Fitting The Harness; Adjusting The Harness - VERTBAUDET ISOFIX Mode D'emploi

Fitting the harness

Put the harness shoulder straps in one of the two positions indicated (14) so that they
always pass over your child's shoulders (see paragraph on "Adjusting the harness").
To tighten the harness: Pull on the adjusting straps positioned on the harness. You do
not need to press on the adjuster buttons (15).
IMPORTANT: A poorly fitting harness can be dangerous. You should not be able to
insert two fingers between the shoulder strap and your child's chest.
To loosen the harness: Press on the adjuster buttons positioned on the upper section
of the harness, grasp the lower section and pull simultaneously (16).

Adjusting the harness

Make sure that the harness of your car seat is adapted to the height of your child before
starting to install the seat in your car.
The harness can be adjusted to two different heights. The straps must pass through the
holes that are closest to your child's shoulders. If your child's shoulders are between
two levels, always use the higher of the two.
To adjust the height of the harness, remove the upper section of one of the harness
straps by twisting the metal keeper located behind the backrest and then pulling the
end of the harness strap through the slots of the shell and the cover (17). Feed the end
of the harness strap through the same slots at the desired height, both in the cover and
the shell and reattach it behind the backrest (18). Make sure that the metal anchor is
correctly positioned and that the harness strap is not twisted. Repeat the opera-
tion on the second strap.
Inclining the ISOFIX Car Seat
Push the adjustment lever located under the front of the seat upwards, then pull or
push the base towards or away from you (19).
Removing the ISOFIX Car Seat
Loosen the Top Tether Strap by pulling on the tensioner (20) then release the strap from
its anchor point and bring the strap towards you (21). Pull the car seat using the red
handle on the ISOFIX base (22). On either side of the seat, release the ISOFIX connec-
tors from their anchor points by pulling the release buttons on the connectors towards
you. The indicators will turn from green to red (23) (24). The seat is now unattached
and can be removed from the rear side (25).
Storage of the instruction manual
(26)
Cleaning
All the material can be removed. For light stains, clean with a wet sponge and soapy
water or hand wash at 30°C in soapy water. Do not use bleach, do not iron, do not
machine wash, do not dry in a tumble-dryer.
14
GB - User guide