Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
9. Safety pad + harness shoulder strap (x2)
10. Top Tether Strap
11. ISOFIX connector release button (x2)
12. ISOFIX system strap
Fitting the ISOFIX Car Seat
WARNING ! Your ISOFIX Group 1 Car Seat MUST be fitted using the Top Tether
Strap provided ! Your child's safety cannot be guaranteed if you fit your ISOFIX
Group 1 Car Seat without using the Top Tether Strap.
Fold the Top Tether Strap over the back of the car seat so that it does not get trapped
during installation (2). Extend the ISOFIX connectors from the car seat as much as
possible by pulling simultaneously on the red handle on the base and the red ISOFIX
system strap (3).
Position the car seat on the vehicle's rear seat and bring the ISOFIX connectors so that
they are in line with the seat's ISOFIX anchor points (4). Click the ISO connectors into
the anchor points; the indicators on each connector should turn from red to green (5).
Release the safety catch of the ISOFIX system by pulling the red handle attached to
the base and gently pushing the car seat (6). With the safety catch released, push the
car seat by exerting equal pressure on both sides until the rear of the car seat is pressed
firmly against the rear seat (7).
Bring the Top Tether Strap over the vehicle's rear seat and attach the clasp to the vehi-
cle's Top Tether anchor point (8).
The additional Top Tether anchor point may be located, depending on the make of
your car:
•
Behind the vehicle's rear seat.
•
On the floor, at the rear of the vehicle.
•
On the ceiling, at the rear of the vehicle.
Refer to your car user manual to locate the additional Top Tether anchor point. Never
attach the Top Tether to a point that is not recommended by the vehicle manufacturer.
Never alter the vehicle yourself in order to try and fasten the Top Tether (e.g. by pierc-
ing, screwing or attaching an anchor point).
Push the seat against the back of the rear seat and pull on the loose end of the Top
Tether Strap. When the belt is as taut as it will go, the indicator on the Top Tether Strap
will turn from red to green (9).
Belt buckle
To fasten the harness, bring the two shoulder straps together
into the buckle; you should hear a "click" (12).
To release the harness, press the buckle's red button (13).
Some ISOFIX car seat models are fitted with an optional alarm. The alarm sounds to
alert the parents if the child releases the buckle during a journey.
(10) (11)
and insert them
13
User guide - GB
Publicité
Table des Matières
