Product Description - Omega Lift Equipment 93200 Instructions D'utilisation Et Manuel De Pièces

Save these instructions. For your safety, read, understand and follow the information contained within. The owner
and operator shall have an understanding of this product and safe operating procedures before attempting to use
this product. Instructions and Safety information shall be conveyed in the operators native language before use of
this product is authorized. Make certain that the operator thoroughly understands the inherent dangers associated
with the use and misuse of the product. If any doubt exists as to the safe and proper use of this product as outlined
in this factory authorized manual, remove from service.
Inspect before each use. Do not use if there are broken, bent, cracked or otherwise damaged parts (including
labels). If the ramp operates abnormally, discontinue use until inspected by an Omega authorized service center.
Owners and operators of this equipment shall be aware that the use of this equipment may require special training
and knowledge. It is recommended that an annual inspection be done by qualified personnel and that any missing or
damaged decals, warning / safety labels or signs be replaced with factory authorized replacements only. Any truck
ramp that appears to be damaged in structure shall be removed from service and destroyed immediately.

PRODUCT DESCRIPTION

Omega Truck Ramps are designed to safely support rated capacity vehicles for extended periods. Truck ramps are
not to be used to simultaneously support both ends or one side of a vehicle. Heavy gauge steel frame helps prevent
distortion and twisting. These ramps comply with applicable ASME / ANSI Standards to ensure safety, strength and
stability.
NOTICE: RATED CAPACITY IS PER PAIR ONLY! TRUCK RAMPS MUST BE USED IN PAIR AND USE ONLY
ONE PAIR PER VEHICLE.
DO NOT USE FOR ANY PURPOSE OTHER THAN THOSE USES OUTLINED ABOVE!
SPECIFICATIONS
Model
93200
93201
Ramp Slope
Base
Capacity Product Size (L x W x H)
45 5/8" x 13 1/2" x 9 1/4"
20 Ton
45 5/8" x 18 1/4" x 9 1/4"
Figure 1 - Truck Ramp Components
Handle Length
33 3/4"
Support Platform
Wheel
2
Max. Vehicle Tire
Width
11-1/4"
16"
Handle