Sharp MX-B350P Guide De Démarrage page 12

REPLACEMENT OF TONER CARTRIDGE
Always replace the toner cartridge after the "Change the toner
cartridge." message appears. You should keep one set of
replacement toner cartridges on hand so that you can replace
a toner cartridge immediately when toner runs out.
For detailed procedures for replacing the toner cartridge, see
the User's Manual.
(1) Open the front cover.
•
(2) Pull the toner cartridge toward you.
Gently pull out the toner cartridge horizontally.
If the cartridge is pulled out abruptly, toner may spill out.
•
Hold the toner cartridge with both hands as shown and
slowly pull it out of the machine.
•
(3) Take out a new toner cartridge from its
package and shake it horizontally five or six
times.
•
(4) Slowly insert the new toner cartridge on the
level.
10
(5) Press in firmly until you hear a "click"
sound.
•
(6) Close the front cover.
After the toner cartridge is replaced, the machine
automatically enters image adjustment mode. Do not
open the front cover while this is occurring.
Notice for users in the UK
MAINS PLUG WIRING INSTRUCTIONS
The mains lead of this equipment is already fitted with a mains plug
which is either a non-rewireable (moulded) or a rewireable type.
Should the fuse need to be replaced, a BSI or ASTA approved
fuse to BS1362 marked
the one removed from the plug must be used.
Always refit the fuse cover after replacing the fuse on the
moulded plug. Never use the plug without the fuse cover fitted.
In the unlikely event of the socket outlet in your home not being
compatible with the plug supplied either cut-off the moulded
plug (if this type is fitted) or remove by undoing the screws if a
rewireable plug is fitted and fit an appropriate type observing
the wiring code below.
DANGER: The fuse should be removed from the cut-off plug
and the plug destroyed immediately and disposed of in a safe
manner. Under no circumstances should the cut-off plug be
inserted elsewhere into a 13A socket outlet as a serious
electric shock may occur.
To fit an appropriate plug to the mains lead, follow the
instructions below:
IMPORTANT: The wires in this mains lead are coloured in
accordance with the following code:
GREEN-AND-YELLOW:
BLUE:
BROWN:
As the colours of the wires in this mains lead may not
correspond with coloured markings identifying the terminals in
your plug, proceed as follows:
The wire which is coloured GREEN-AND-YELLOW must be
connected to the terminal in the plug which is marked with the
letter E, or by the safety earth symbol
greenandyellow.
The wire which is coloured BLUE must be connected to the
terminal which is marked with the letter N or coloured black.
The wire which is coloured BROWN must be connected to the
terminal which is marked with the letter L or coloured red.
If you have any doubt, consult a qualified electrician.
WARNING: THIS APPARATUS MUST BE EARTHED.
or and of the same rating as
Earth
Neutral
Live
, or coloured green or