Sharp MX-B350P Guide De Démarrage page 10

Misfeed in the paper feed area A
(1) Carefully remove the misfed paper. Turn
the roller rotating knob in the direction of
the arrow to assist in removing it.
Be careful not to tear the misfed paper during removal.
The fusing unit is hot. Do not touch the fusing unit when
removing misfed paper. Doing so may cause a burn or injury.
Roller rotating knob
(2) Close the side cover.
The message " Clear paper path." will be cleared and
printing will be possible.
Misfeed in the paper feed area B
(1) Lift the fusing unit pressure adjusting
levers to allow easier removal.
Fusing unit pressure adjusting levers
(2) Remove the misfed paper.
Be careful not to tear the misfed paper during removal.
The fusing unit is hot. Do not touch the fusing unit when
removing misfed paper. Doing so may cause a burn or
injury.
8
Fusing unit
(3) If the misfed paper cannot be removed,
remove the paper by pulling it into the
paper output area.
(4) Lower the fusing unit pressure adjusting
levers, to return them to their operating
positions.
(5) Close the side cover.
The message " Clear paper path." will be cleared and
printing will be possible.
Misfeed in the transport area C
(1) Remove the misfed paper.
Be careful not to tear the misfed paper during removal.
(2) Return the duplex conveyor lever to its
original position and close the side cover.
The message " Clear paper path." will be cleared and
printing will be possible.