Resolving Problems; Cleaning And Maintenance - Tyro Musca Mode D'emploi

8. Aquarius receiver connection diagram

9. Resolving problems

If the equipment is not working properly, check the following points:
The receiver does not react when you give a command on the transmitter
The receiver does not have any power
 Make sure the receiver is connected correctly and the fuse is intact
You are out of range of the receiver
 Make sure you are within range of the receiver and there are no large (metal) objects between you and the receiver or aerial of the
receiver
 If necessary, the antenna can be installed in another place with the aid of an antenna extension cable.
The transmitter is not programmed to the receiver
 Follow the steps in section 5 to program the transmitter to the receiver
The transmitter does not work
The transmitter does not switch on if you press the ON-button
 The battery may be empty; change the battery
 If this is not the solution, then the transmitter maybe defective and you should offer the system for repairs
The range is too small
The antenna is not properly installed on top of the receiver.
 See guidelines provided in chapter 5, antenna installation
The antenna has not been positioned correctly.
 See guidelines provided in chapter 5
Service
If a Tyro Remotes remote control has a problem or requires service, please send the entire system (transmitter and receiver) to Tyro Remotes
for repairs. To ensure that this occurs smoothly, please print out the service form, fill it in and send it to us together with the system. The service
form can be downloaded from www.tyroremotes.com/support/repairs. If the repairs are not free, we will always inform you of this in advance.

Cleaning and maintenance

 Do not use chemical cleaning agents or abrasives to clean the device
They can affect the operating panel
We recommend using a damp cloth and slightly soapy water
 If the device becomes very dirty, please contact Tyro Remotes to consult on how to best clean it
 Never submerge the device in water or other liquids. If you do so it could damage the device
 Make sure that no water gets into the device. If it does, do not use the device until it has completely dried out and has been tested
Conditions of sale and certification
All deliveries are made according to our conditions of sale. These are available upon request or can be downloaded directly from our website
(www.tyroremotes.com). The products are certified for many applications. These certificates are also available upon request. You yourself are
responsible for keeping in account which machine directive guidelines apply for your situation. When you outfit you're machine by default with a
Tyro remote control, the certification of the machine as a whole – including remote controle system – is your responsibility.
PLEASE NOTE: Tyro Remotes is not responsible for personal, material and consequential
damages caused by improper or careless use, which are in conflict with the provisions,
instructions and guidelines included in this manual
Publisher:
Tyro Remotes, 08/2016
All manuals and user guides at all-guides.com
Revision number:
4042.V1.3
Manufacturer: Tyro Remotes
Bedrijvenpark Twente 1b, 7602 KA Almelo
Figure 5
12