Assembly Of A Standard System; Range Optimisation - Tyro Musca Mode D'emploi

4. Assembly of a standard system

For the range to be optimal the location of the receiver is of great importance, there for take chapter 5 in account.
After connection and assembly the system must be tested before switching on the mains.
PLEASE NOTE: if you have a customised product, the cable connection and assembly may
differ. Please always read your specific manual first!
PLEASE NOTE: the Aquarius must always be connected
to the power source behind a main fuse!
The standard cable connection is as follows:
Key
1
2
3
4
5 or Stop button
6
ON
OFF
Power supply 8-36 Vdc / V+
Common / V-
Input 1
Input 2

5. Range optimisation

The location of the receiver is of great influence on the maximum range, there for take in
account the following points in order to optimize the range of the system:
- Place several receivers at least 50cm apart
- Never directly place the receiver or antenna on metal objects but at least 50 cm away
- Mount the receiver or antenna approximately 3 to 4 metres above work height, higher or
under work height reduces range significantly
- Place the receiver or antenna at least 50 cm away from engines or other devices that can generate a force field
- Never place the receiver with antenna in the cabin of a vehicle, a switchbox, or a similar (metal) casing
- If the receiver needs to be placed in an unfavourable location, the antenna can be placed elsewhere using an antenna extension cord
- If possible try to maintain a line of sight with the receiver during operation
Range
The maximum range indicated is based on a measurement with line of sight without interference
The indicated range cannot be guaranteed because it is always subjective to variable environmental factors
In particular deflection, reflection and shadows can decrease the maximum range
Objects present in between the transmitter and receiver, in particular metals, reinforced concrete or absorbing objects like trees or snow, have
an unpredictable influence on the maximum range
In general the optimal range can be achieved when there is a line of sight between the transmitter and the receiver
Frequencies
Check if there are no other wireless devices that operate on the same frequency, this will have a negative impact on the performance and range
of the system.
Antenna installation
Put the antenna on the BNC connector on top of the receiver, squeeze the bottom side of the antenna together and turn clockwi se until you feel
it lock in place. Pull lightly on the antenna to check if it is secure. The antenna is still able to turn around.
Publisher:
Tyro Remotes, 08/2016
All manuals and user guides at all-guides.com
Wire number
Green/yellow
Revision number:
4042.V1.3
5
4
2
3
6
7
-
-
1
8
9
Manufacturer: Tyro Remotes
Bedrijvenpark Twente 1b, 7602 KA Almelo
Figure 3
10