Shutdown Instructions - Mr. Heater MH18B Instructions D'utilisation Et Manuel Du Propriétaire

NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING! NEVER LEAVE THE HEATER UNATTENDED WHILE BURNING!
1 1. For added heat circulation turn red fan
switch to on. The fan switch is located
just left of control knob side handle
support. See Figure 1.
12. Installation of 4 D-cell batteries is
required for fan operation. Battery
box is located on lower back panel of
heater. Follow instructions on battery
cover for correct battery installation.
See Figure 6.
13. Heater fan can also be powered by
electrical adapter F276127. Required
adapter to be 6 volt DC up to 800
milliamp current with positive tip
polarity. See Figure 6.

Shutdown Instructions

1. To shut off heater, slightly push down
and turn Control Knob clockwise to
"OFF" position.
• Do not operate, store or remove
cylinder near flammable items or
ignition sources.
LP-GAS CYLINDERS MUST BE
DISCONNECTED FROM HEATER WHEN
NOT IN USE!
LIGHTING / OPERATING
INSTRUCTIONS FOR USE
WITH HOSE CONNECTED
TO A REMOTE CYLINDER,
MAXIMUM SIZE 20 LBS:
• This heater may be operated with
Mr. Heater Hose No. F271802 which
includes a quick disconnect fitting
and a 3/8" female flare fitting
connected to a regulated (1 1" W.C.)
propane source or Mr. Heater Hose
No. F271803 which includes a quick
disconnect fitting and a 1 1" W.C.
regulator.
• Inspect the hose before each use
of the heater. If there is excessive
abrasion or wear, or the hose is cut,
replace prior to using the heater with
one of the Mr. Heater Hose No's.
shown above.
• The propane cylinder must include a
listed overfilling protection device as
well as a collar to protect the cylinder
valve.
• The propane cylider must also be
used with Tankfoot F273169. Place
holder on flat surface then place 20 lb.
cylinder in holder and push down to
bottom.
• Heater must be in an upright position
during operation.
1. Make sure five-position Control Knob is
in "OFF" position. See Figure 1.
Mr. Heater | Portable Big Buddy Radiant Heater
2. Mr. Heater strongly recommends using
disposable fuel filter F273699 to trap
any oil substances when connected
to a remote cylinder that can make
heater inoperable.
3. Screw hose connector into tank swivel
or fuel filter on heater or connect to
quick disconnect and screw connector
on other end of hose into LP gas tank
valve. Tighten all hose connections.
DO NOT use thread sealant on any of
these connections.
4. Open valve at LP-gas supply cylinder.
5. Check all hose connections for leaks
with soapy water at the threaded
connection under the domed plastic
cover where the hose connector
screws into the regulator and at LP-gas
supply cylinder. SEE WARNING! ON
PLASTIC DOORS.
6. Depress and turn Control Knob
counterclockwise to "PILOT" position
and hold down for 1 - 5 seconds.
See Figure 4. This may take longer
to purge air from the supply hose
depending on the length of the hose
being used.
7. While holding down the control knob,
rotate clockwise to the OFF position
and immediately turn back to the pilot
position, a spark will be generated
at the pilot assembly and the heater
should light. If the heater does not
light on the first attempt, repeat the
procedure.
8. Once the pilot has lit, hold the control
knob down for an additional 30
seconds to heat the thermocouple.
After 30 seconds, release the control
knob and the pilot should remain lit. If
the pilot goes out repeat the lighting
procedure.
9. After lighting pilot, release knob.
Knob should return to fully extended
position. See Figure 5.
10. Turn control knob to "LO" or "MD"
position to light heater. Leave on "LO"
or "MD" position until first burner tile
has turned bright orange.
1 1. After first burner tile has turned bright
orange, adjust heat output by turning
Control Knob to desired position
("LO", "MD" or "HI" setting).
12. For added heat circulation turn red fan
switch to on. The fan switch is located
just left of control knob side handle
support. See Figure 1.
5
Operating Instructions and Owner's Manual
¥
¥
¥
Figure 4
Figure 5
Electrical Adapter Outlet
Electrical Adapter and Batteries
Not Included
Figure 6
WARNING: ANY HOSE CONNECTION
TO A QUICK DISCONNECT FITTING ON
HEATER MUST BE REGULATED TO 1 1"
W.C. PRESSURE.
CAUTION: After turning heater off,
wire guard will remain hot. Allow to
thoroughly cool before storing.
DANGER: NEVER bring a refillable
propane cylinder indoors. A fire or
explosion can occur causing property
damage, serious injury or death!