Pump Operation; Maintenance And Storage - Bestway 65315 Instructions De Fonctionnement

WARNING:
1. The pump can only be used with attached car plug.
2. The pump must only be used at extra low voltage (DC12V for safety.)
3. Switch off the pump and disconnect the pump from the power supply before maintenance.
4. To avoid the risk of electric shock, do not use damaged power cords. Damaged power cords should be discarded. Do not attempt to repair damaged
power cords.
5. Inflation and deflation ports should be kept free of debris during use.
6. Never leave the pump unattended while the pump is in use.
7. The appliance must be stored in a dry location.
8. Do not use the pump continuously for more than 15 minutes. It can only be used again after at least 30 minutes of cooling.
9. This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of
experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards
involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.(For EU market)
• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children
should be supervised to ensure that they do not play with the appliance.(For market other than EU)
10. Cleaning and maintenance must be performed by an adult age 18 or over, who is familiar with the risk of electric shock.
11. The product cannot be used in a flammable or explosive environment.
12. This product may only be used with the original hose.
13. Ensure the hose, switch, cigarette lighter, and pressure screen are working properly before using the pump.
14. Keep away from heat source, humidity, dust and direct sunlight.
15. According to the standard of EN ISO 2151, the tested load acoustic power value of the device during operation is 97dB, the sound pressure value is
85dB, and the uncertainty is 3dB.
16. If the pump cannot inflate the SUP board to the set pressure, the car battery is not strong enough. Please use another car.
17. IMPORTANT: When inflating the SUP board, it is recommended to keep the car on. This will increase the battery's output and the pump's performance.
18. Adapted air pressure of this pump is 2~16 PSI.
19. This pump also can be adapted for most professional boats with working pressures between 2-16 PSI.
20. Important: Set up the connect pressure on the electrical pump before inflation. Don't set a higher pressure on the electrical pump, as it will cause over
inflation and possible damage to the products and the pump.
NOTE: This product is not intended for commercial use.
NOTE: Drawings for illustration purpose only. May not reflect actual product. Not to scale.
21. If the supply cord is damaged, it must be replaced by the qualified persons in order to avoid a hazard.
22. Please use this equipment at ambient temperature of no more than 40 degrees.
23. The pressure line of the product is only suitable for the original wave pipe.
24. Be sure to check if the wave pipe is broken, and make sure the switch, the cigarette lighter and the pressure screen really work prior to use.
NOTE: Two kinds of gaskets can be optional with different sizes of air valve, the joint gasket is matched with our air valve by default.
MEANING OF CROSSED-OUT WHEELED DUSTBIN:
Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with your local authority or
retailer for recycling advice.

PUMP OPERATION

1.
NOTE: 1. Press " " or "
+
2. The pump will stop automatically when the internal pressure reaches the set value.
3. The factory set pressure value is 10 PSI (0.689 BAR). Each time the pump is turned on, it automatically sets to the last used pressure value.
4. After 2 minutes without use, the pump automatically enters Standby Mode. The machine can be turned back on by pressing "
5. The " " means the voltage of the car battery is too low, and "

MAINTENANCE AND STORAGE

1. Pull the DC plug from the socket after each use or before moving or adjusting the pump.
2. Store the pump after it has cooled down. Do not expose it to rain or immerse it in water.
3. Please store it in the dry and ventilated place.
4. Wipe the fuselage with soft dry cloth dipped in 75% concentration of medical alcohol.
5. Avoid dropping or shaking the body.
6. The product shall be verified the pressure display equipment and checked whether the equipment is malfunctioned by the professional maintenance
personnel regularly.
12V AUTO-AIR ELECTRIC PUMP
ORIGINAL OPERATING
INSTRUCTIONS
65315
NOTICE: READ CAREFULLY BEFORE OPERATING
CAUTION:
2.
" to increase or decrease the pressure value, press "
AND SAVE THESE INSTRUCTIONS.
TO AVOID THE RISK OF ELECTRIC
SHOCK, DO NOT EXPOSE TO WATER
OR RAIN.
3.
" switch the unit measurement, and press "
PSI/BAR
" means the voltage of the car battery is too high.
2
4.
" to stop.
".