Purpose Of This Manual; Safety Information - Battipav PRIME Serie Mode D'emploi

Battipav srl

PURPOSE OF THIS MANUAL

This manual is an integral part of the machine.
It was produced by BATTIPAV S.R.L. to provide those authorised to work with the machine with the information
required for its foreseeable lifespan.
Before starting to use this machine read the safety chapter carefully.
Each machine is subjected to a series of tests and carefully checked before leaving our factory.
BATTIPAV S.R.L. is constantly striving to develop their machines and therefore reserves the right to make any
change without prior notice. Therefore, no claims may be made on the basis of the data and illustrations contained
in this manual.

SAFETY INFORMATION

• The manufacturer accepts no responsibility where the PRIME / SUPREME cutter is used with any tools other
than those specified in the "RECOMMENDED USE" paragraph.
DO NOT USE WOODEN DISCS. DO NOT USE DRY-CUTTING DISCS.
• PRIME / SUPREME is made to operate exclusively under the conditions indicated under "TYPE OF OPERATION
ALLOWED", in the "TECHNICAL DATA" paragraph.
• During cutting operations, allow the machine to rest as indicated.
• PRIME / SUPREME is not made for use with a continuous load.
DO NOT USE DIAMOND TIPPED DISCS OF LOW QUALITY OR THAT ARE NOT SUITABLE FOR
THE SPECIFIC USE FOR WHICH THE MANUFACTURER SUPPLIED THEM. THE USE OF POOR
QUALITY DISCS CAN HARM THE OPERATOR AND DAMAGE THE MACHINE, AS WELL AS
SIGNIFICANTLY SLOWING THE WORK.
THE MACHINE IS NOT INTENDED FOR USE IN AN EXPLOSIVE ENVIRONMENT.
ALWAYS USE INDIVIDUAL PROTECTION DEVICES TO REDUCE THE RISKS CAUSED BY WORK.
NEVER START THE MACHINE WHEN THE CUTTING TOOL IS MOVING; WAIT FOR IT TO STOP.
Each time the machine is connected to the power supply, check the correct direction of rotation
of the motor indicated on the disk protection. ALWAYS PERFORM THE ROTATION DIRECTION
VERIFICATION OPERATION WITH DISASSEMBLED CUTTING DISC.
DO NOT USE THE MACHINE FOR ANY REASON WITH THE DIRECTION OF ROTATION CONTRARY TO
THAT INDICATED.
Warning! When using electric tools, following safety precautions should always be followed to reduce the risk
of fire, electric shock and personal injuries. Read and follow all these instructions before attempting to operate
this product and save them with care!
Keep your work area perfectly clean
• Cluttered areas invite injuries.
Consider work area environment
• Don't expose tools to rain. • Don't use tools in damp or wet locations. Keep work area well lit.
• Don't use tools in presence of flammable liquids or gases.
Guard against electric shocks
• Prevent body contact with grounded surfaces.
Keep children away!
• Do not let third parties contact tool or extension cord. All visitors should be kept away from work area.
Store your tools in a save place
• When not in use, tools should be stored in dry and save places, out of the reach of children.
Don't force tool
• It will function better and in a safer way at the rate for which it was intended.
"TRANSLATION OF THE ORIGINAL INSTRUCTIONS"
SAVE THESE INSTRUCTIONS WITH CARE.
GB
45