Battipav PRIME Serie Mode D'emploi page 48

GB
IN ORDER NOT TO COMPROMISE THE MACHINE STABILITY, KEEP STRICTLY TO THE FOLLOWING
PROCEDURES. WITH THE AID OF A SECOND PERSON, HOLD THE MACHINE DURING THE WHEEL KIT
INSTALLATION OPERATIONS.
When the machine is in working position (See paragraph: Positioning):
a) loosen the left leg locking pin (motor side);
4 b) lift the leg and put it in the wheel support;
c) lock the leg with the relative locking pin;
d) tighten the wheel support setscrew;
4
e) repeat the operation for the right wheel.
IN ORDER TO FACILITATE THE PRIME / SUPREME MACHINE MOVEMENT IN THE YARD, WE RECOMMEND
LOWERING IT UNTIL THE LOWERED POSITION WITH THE AID OF A SECOND PERSON AS DESCRIBED BELOW:
a) loosen the leg locking pins on the front side, one at a time, holding the machine from the transport handles;
b) lower the machine front side, making the legs slide inside the supports until the leg middle hole matches
5
the hole of the supports (see picture 5);
c) lock the legs by means of the relevant leg locking pins;
d) repeat the operations indicated in points (a), (b), (c) for the rear side.
6 MOVE THE MACHINE
POSITIONING
Place the machine on a stabile surface.
To place the machine in working position, proceed as follows:
MAKE SURE THAT THE MOTOR HEAD IS LOCKED BY MEANS OF THE LOCKING KNOB LOCATED ON
THE SLIDE RAIL
7
a) put the leg locking pins in release position;
b) by means of the transport handles, lift one side of the machine until the working position .
7
FOR CORRECT MACHINE POSITIONING, MAKE SURE THAT THE LEG UPPER HOLE MATCHES THE LEG
8
COUPLING HOLE, BEFORE FINALLY LOCKING IT.
c) lock the legs one at a time.
8
HOLD THE MACHINE DURING THE LOCKING PHASES.
d) Repeat the operation for the opposite side;
9 e) Loosen the carriage locking knob located on the slide rail.
f) Engage the water hose on the water on-off valve.
10
g) Insert the tube-holder rod in its seat.
11
CHECKING BEFORE USE
THE PRIME MACHINE HAS BEEN DESIGNED FOR WORKING EXCLUSIVELY WITH WATER.
• Before any cutting operation, make sure that the water level inside the tank is correct.
12
Before using the machine, check there is power supply.
CONNECTING TO POWER SUPPLY
THE MACHINE IS TO BE CONNECTED TO THE POWER SUPPLY BY A RESIDUAL CURRENT
CIRCUIT BREAKER (RCCB) WITH THE FOLLOWING CHARACTERISTICS:
RCCB In 16 A Id 30 mA
N.B. To ensure correct functioning, periodically check the efficiency of RCCBs by pressing the push-button on
the front of the device.
• Make sure that the section of the power supply cable cores has been measured according to the starting
48
Battipav srl