Battipav EXPERT 400 Mode D'emploi page 47

Battipav srl
MAINTENANCE
BEFORE PERFORMING ANY OPERATION OR ADJUSTMENT, DISCONNECT THE MACHINE FROM THE SUPPLY
MAINS.
CLEANING
DO NOT WASH THE MACHINE WITH HIGH PRESSURE WATER JETS
Through the tap located on the bottom of the recovery tank, remove any working residual from the machine.
33 34
Clean the sprayer regularly as indicated.
35
Clean the slide guides regularly to remove cutting residues.
MOTOR HEAD INCLINATION ADJUSTMENT
The head unit is provided with a register for adjusting the cutting at 90°.
FOR EXPERT 500/600
36
1) loosen the register (B) fixing nut (A) with a 13 mm wrench, and use it for moving the motor head to the correct position.
2) lock the register again with the fixing nut (A)
FOR EXPERT 700
37
1) loosen the motor head locking lever.
2) use the hand wheel for moving the head to the correct position
3) lock the register again by means of the locking lever.
FOR THE CORRECT POSITIONING OF THE REGISTERS, USE A SQUARE SHOWING THE 45°.
SLIDING CARRIAGE ADJUSTMENT
The sliding carriage is provided with a register for adjustment.
If any excessive vertical movement of the carriage should take place, act as follows:
38
1) with a 13 mm wrench and a 6 mm Allen wrench, loosen the lower wheel supports.
39
2) make the lower wheel support slide on the adjustment slot until the vertical play is eliminated.
3) lock the lower wheel support again.
IN CASE OF LATERAL MOVEMENTS OF THE CARRIAGE, TIGHTEN ALL THE WHEEL SUPPORTS STILL FURTHER.
DISPOSAL
In the event of scrapping the entire machine, it must be disposed of in accordance with the methods laid down by current legislation.
Main Casing
Submerged Pump
Electric Motor
R.A.E.E. IT08020000002803
The European Directive 2012/19/EU arranges that in the event of scrapping of electrical equipment, they must not be
disposed of city solid refusals but collected separately, in order to optimize the level of recovery and recycling of the
materials and above all in order to prevent damages to health and environment. To comply with European Directive
2012/19/EU, all electrical equipments must be marked with crossed basket symbol. The packing of the machine will be
disposed of in accordance with the methods laid down by current legislation. For further information concerning disposal of
electrical equipment, please refer to public administration service.
Polyamide Steel Alluminio Copper
GB
Epoxy Resin
47