Battipav EXPERT 400 Mode D'emploi page 45

Battipav srl
BLADE ASSEMBLY / DISASSEMBLY
Before performing any operation or adjustment, disconnect the machine from the supply mains.
16
Unscrew the knobs and the locking nut located on the disc cover and remove it.
Remove the blade fixing nut using the 30 mm spanner and the 5 mm Allen wrench.
THE BLADE FIXING NUT HAS A LEFT-HAND THREAD.
• Install the new blade, checking for correct direction of rotation as clearly indicated on the tool.
• Tighten the blade and put the blade cover guard back in position.
IN ADDITION TO THE KNOBS ALWAYS REASSEMBLE THE LOCKING NUT ON THE DISC COVER.
FOR THE BLADE DISASSEMBLY OPERATIONS, PROCEED AS INDICATED BELOW.
17
Wearing gloves to protect your hands, hold the diamond blade firmly and use the other hand to unscrew the fixing nut with a
30 mm spanner.
CONTROL DEVICES
19 20
The EXPERT machine is equipped with a control board made up of:
1) START BUTTON: (GREEN COLOUR for EXPERT 400, BLACK COLOUR for EXPERT 500/600 and 700)
Press the button fully to activate machine starting.
2) REGULAR STOP BUTTON: (RED COLOUR)
Press the button fully to activate machine stop.The device has an interlocking system. Before starting the machine, make
sure that the device is in release position. Turn it 90° clockwise to unblock it.
3) DEVICE FOR DISCONNECTION FROM THE MAINS (Plug)(EXPERT 400):
Machine power supply point. During the maintenance phases, take out the plug from the device in order to disconnect the
machine from the mains.
4) MAINS PRESENCE WARNING LIGHT (WHITE)(EXPERT 400):
On: presence of mains voltage. Off: lack of mains voltage.
5) MACHINE OPERATION WARNING LIGHT (GREEN)(EXPERT 400):
It indicates that the machine is working.
6) OVERCURRENT CIRCUIT BREAKER(EXPERT 400):
It intervenes when there is overcurrent, interrupting the machine supply. Its intervention is indicated by the expulsion of the
manual reset. In case of intervention of the circuit breaker, wait a few minutes and reset it by pressing its central pin.
7) LASER MARKER(EXPERT 400):
It projects the cutting line on the table. It is enabled when the machine is connected to the mains.
CUTTING ON THE TABLE
BEFORE PERFORMING THE CUTTING OPERATIONS, MAKE SURE THAT THE MATERIAL IS PROPERLY LEANED
AGAINST THE TILE STOPPER.
21
BEFORE STARTING THE CUTTING OPERATIONS, THE OPERATOR MUST MAKE SURE THAT AT LEAST 150 cm ARE
LEFT FREE AROUND THE MACHINE (Pos. 2 Picture 21). IN ORDER TO WORK IN SAFETY CONDITIONS, DO NOT LET
OTHER PEOPLE REMAIN NEAR THE MACHINE DURING THE CUTTING OPERATIONS. THE OPERATOR STANDS IN
THE WORKING POSITION (Pos. 1 Picture 21) DURING THE DIFFERENT MACHINE OPERATION PHASES.
22
By means of the locking lever, secure the motor head
• Arrange the piece to be cut on the working table at the desired measurement.
23
• Start the machine and wait until cutting blade cooling water comes out, adjusting the necessary amount by means of the
water on-off valve located on the blade guard
25
• Start the machine and wait until cutting blade cooling water comes out, adjusting the necessary amount by means of the
water on-off valve located on the blade guard.
24
In order to carry out any diagonal cutting, lean the piece against the square as indicated in the picture and go on with the
cutting operation.
CUTTING ON THE TABLE IN 2 PASSAGES
By adjusting the position of the cutting head using the locking lever, it is possible to cut materials of a height of up to 130 mm in 2 passages.
GB
45