Electrical Connections - Pinguino PAC L90 Mode D'emploi

I n s t a l l i n g y o u r p o r t a b l e

ELECTRICAL CONNECTIONS

Before plugging the appliance into the electrical socket, check that:
• the power supply corresponds to the value indicated on the rating plate on the back of the appliance;
• the socket and electrical circuit are adequate for the appliance;
• the socket matches the plug. If this is not the case, have the plug replaced;
• the socket is adequately grounded. Failure to follow these important safety instructions absolves the manu-
facturer of all liability.
The power cord must be replaced by a qualified professional only.
The instructions below will enable you to prepare your air conditioning unit for operation as effi-
ciently as possible.
Before use, make sure the air intake and outlet grilles are unobstructed.
NON PERMANENT INSTALLATION
Just a few simple steps and your comfort is
ensured with Pinguino:
• Fit the air exhaust hose
6
at the back of the appliance. Insert it as
shown in figure A.
In order to improve the performance of the
appliance in air conditioning and boost
(super-conditioning) modes, you can also fit
the intake hose accessory
the back of the appliance as shown in figure
A1. This step is optional.
A
• Fit the window outlets
11 18
the hose .
/
• Place the air conditioning unit near a win-
dow or French window.
• Make sure the air exhaust hose is unob-
structed.
Keep air hoses as short and free of cur-
ves as possible to avoid constrictions.
All manuals and user guides at all-guides.com
a i r - c o n d i t i o n e r
11
in the housing
18 in its housing in
A1
12
to the end of
Sash window
For optimum results:
• If you have a sash window, place the
16 17
bracket or
needs , on the window sill,extend the bracket
fully within the window frame, fix the bracket
by using the pin then lower the window onto
the bracket. Insert the window outlet
11
the exhaust hose
then connect the hose to the air conditioner
(fig. B and B1).
Thanks to the locking pins, it's possible to use
the window bracket also for sliding windows.
Position the hole of the bracket so to allow a
correct installation of the exhaust hose.
B
French window
C
according to your
12
of
into the slot,
B1
C1
5