Stihl FSE 60 Notice D'emploi page 30

English
Check that the cutting attachment is
–
properly and securely mounted and
in good condition.
Check protective devices (e.g.
–
deflector for cutting attachment) for
damage or wear. Always replace
damaged parts. Never operate the
unit with a damaged deflector.
Keep the handles dry and clean –
–
free from oil and dirt – for safe
control of the power tool.
Adjust handle to suit your height and
–
reach.
To reduce the risk of accidents, do not
operate the unit if it is not properly
assembled and in good condition.
Do not operate your power tool if any of
its components are damaged or not
properly mounted.
Never attempt to modify the controls or
the safety devices in any way.
Before switching on your power tool,
make sure the cutting attachment is not
touching the ground or any other object.
To reduce the risk of
injury, avoid contact with
the cutting attachment.
Note that the cutting
attachment continues to
run for a short period
after the power tool is
switched off – flywheel
effect.
28
Electrical Connection.
Reduce the risk of electric shock:
Voltage and frequency of the power
–
tool (see rating plate) and the
voltage and frequency of your
power supply must be the same.
Check the connecting cord, plug
–
and extension cord for damage.
Never use damaged cords,
couplings and plugs or connecting
cords that do not comply with
regulations.
Always connect the power tool to a
–
properly installed wall outlet.
Check that the insulation of the
–
power cord, extension cord, plug
and coupling is in good condition.
Never touch the mains plug,
–
connecting cord, extension cord or
electrical connections with wet
hands.
Make sure the extension cord used
–
complies with the regulations for the
intended application.
Position the connecting and extension
cords correctly:
Check minimum cross section of
–
wires (wire gauge) – see
"Connecting to Power Supply".
To reduce the risk of stumbling,
–
position and mark the connecting
cord so that it cannot be damaged
or endanger others.
Using unsuitable extension cords
–
can be dangerous. Use only
extension cords approved for
outdoor use which are labeled as
such and have the appropriate wire
gauge.
The plug and coupling of the
–
extension cord must be water-proof
and must never be immersed in
water.
Do not chafe on edges, pointed or
–
sharp objects
Do not squeeze through gaps in
–
doors or windows
If cords are twisted – unplug the
–
power tool and straighten them out
Never touch the rotating cutting
–
attachment
Always unwind the extension cord
–
completely from the cable drum to
reduce the risk of fire from
overheating.
Holding and Controlling the Power Tool
Always hold the unit firmly with both
hands on the handles. Make sure you
always have good balance and secure
footing.
Always hold the machine on the right-
hand side of your body.
Left hand on loop handle, right hand on
control handle, even if you are left-
handed.
FSE 60, FSE 71, FSE 81