diversey TASKI swingo 455B Mode D'emploi page 67

Notice:
Diversey recommends a sustainable working by de-
termination of the correct product dosing quantity.
Overdosing or underdosing will lead to unsatisfactory
cleaning results.
One-button function
• Switch the machine on.
• To do this, press the main switch but-
ton (ON/OFF) for 3 seconds.
The display lights up briefly.
Notice:
The values preset when switching off the machine
are stored and will be automatically activated when
restarting the machine.
Notice:
The preset values can be adjusted at any time
during operation.
Cleaning start
• Press the operating levers on the
machine handle.
The tool starts to rotate and the
cleaning solution supply starts.
Power off function
Notice:
The machine turns itself off after 5 minutes when no
longer in use.
During these 5 minutes:
• the brushes may not be manipulated in any way.
• the user must not leave the machine out of sight.
• sucked in or jammed objects may be cleaned from the
squeegee only.
• the user is only allowed to leave the machine in order to
clear the work space. The user must maintain visual con-
tact.
Battery capacity - end of operational readiness
• The battery level indicator notifies
you that the machine is ready for op-
eration.
• Blinking red LED:
2 minutes to finish working before the machine automati-
cally switches off.
• Solid red LED:
Requires a full charging cycle.
Cleaning method
Direct working method:
Scrubbing and suction in one work step.
Indirect working method:
Applying the cleaning solution, scrubbing and suction in several work
steps.
Notice:
The machine guiding might be impaired in case of
special combinations of flooring/contamination
and cleaning product.
- Optionally available wheels can improve the traction
of the machine on the floor. Please contact your TAS-
KI customer consultant.
Replenishing cleaning solution
Warning:
The flooring may be damaged when working with-
out cleaning solution.
Caution:
A rattling sound of the pump indicates that the
fresh water tank is empty.
- The pump must never run dry for an extended period.
• The machine must be switched off.
• Open the tank lid.
• Fill the fresh water tank with water, see page 63.
• Add the cleaning product using the dosing cup.
• Close the tank lid.
Draining dirty water
• If the recovery tank is full, the floater
will be sucked onto the suction filter.
This will be indicated by a change of
the noise by increasing the suction
speed as well as residual water at the
bottom.
• Drain the recovery tank, see page 66.
65