Heitronic 36639 Instructions D'installation Et D'utilisation page 5

5. Installation/Commissioning

This product can only be installed by a qualified electrician.

The connection lines in the building must be disconnected before installation and secured against being
switched back on. For this, trip the corresponding fuse switch in the building installation.

Make sure that the surface is suitable for permanently and reliably taking the weight of the light.

Hold the lamp housing at the required assembly position and mark the drill holes. Use appropriate screws
to fix the light. Make sure that no lines are damaged.

Now connect the building installation's connection lines to the screw terminals on the light. Connect the
green-yellow protective conductor first and then the other two cables. The brown (or black) cable is
generally the phase conductor - connect this to the terminal marked with "L". The blue conductor must be
connected to the terminal marked with "N".

Do not bend the cables; make sure that the cables and plugs are not subject to tension or torsional
forces. Protect all cables and insulation against possible damages.

Check proper connection once again.

Switch the building installation's fuse switch back on.
Adjustment of the sensor via the selector switch
Time; Brightness; Range
2 of 3 | 08.10.2018