Relay Play; Recording - Marantz SD4050 Mode D'emploi

í RELAY PLAY (continuous playback of the tapes in deck A and deck B)
¼ Load a cassette tape into deck A and B, and set the Dolby NR button correctoly.
DOLBY NR
C
B
OFF
TIMER
REC
OFF
PLAY
AUTO REVERSE
REV. MODE
AUTO TAPE SELECT/HIGH SPEED DUBBING
CCONT. PLAY
POWER ON/OFF
q
q.
1. REV MODE set to
2. Press the PLAY button w of the deck you first wish to listen to.
3. To stop relay play, press the stop (
¼ Relay play will play deck A and B in succession for 5 times,
(Deck A Deck B Deck A
RECORDING (DECK B only)
¼ Switch on your amplifier or receiver and the source component.
¼ Set the Function Selector or Tape monitor on your amplifier or receiver to the SOURCE or Tape monitor OFF position.
e
DOLBY NR
C
B
OFF
TIMER
REC
OFF
PLAY
REV. MODE
AUTO TAPE SELECT/HIGH SPEED DUBBING
CCONT. PLAY
POWER ON/OFF
r q
1. Press the POWER switch q to the ON (
2. Load the cassette tape w.
(Check that the erasure prevention tabs of the cassette housing
have not been broken off.)
3. Press the DOLBY NR switch e and select the Dolby NR type that
suits the recording.
DOLBY NR
C
B
OFF
4. Select the type of tape transport with the REV MODE switch r.
Mode
To record on only one side
To continuously record on both
sides
All manuals and user guides at all-guides.com
DOUBLE CASSETTE DECK SD4050
COUNTER
RESET
DUBBING SPEED
SYNC REV NORMAL HIGH
STOP PLAY
EJECT
A
PLAY
) e of the deck currently playing the tape.
Deck B Deck A) or (Deck B
DOUBLE CASSETTE DECK SD4050
COUNTER
RESET
DUBBING SPEED
SYNC REV NORMAL HIGH
AUTO REVERSE
STOP PLAY
EJECT
A
PLAY
u
) position.
Switch position
or
w
COUNTER
RESET
REC LEVEL
RECORD PAUSE REC MUTE
STOP PLAY
MIN MAX
PHONES
EJECT
B
PITCH
REC/PLAY
CONTROL – +
e
Deck A Deck B Deck A
!0 ot
COUNTER
RESET
REC LEVEL
RECORD PAUSE REC MUTE
STOP PLAY
MIN MAX
PHONES
EJECT
B
PITCH
REC/PLAY
CONTROL – +
y i u w
5. Press the REC button !0 to set the recording pause mode. The
and indicator will light up.
REC
6. Adjust the recording level with the REC LEVEL control y while
watching the Peak Level Meter.
7. Press the PLAY (
The PLAY and the
8. To pause the recording, press the PAUSE (
the PLAY u or PAUSE button o to resume recording.
9. To stop recording, press the STOP (
Caution:
¼ Be careful not to erase important recordings by mistake.
Inadvertent start of recording will happen in the following cases:
1. If the PLAY button is pressed while the
recording starts.
2. If the PLAY and
recording starts.
The best way to avoid accidental erasure is to break off the two
erasure prevention tabs on the cassette housing.
9
AUTO REVERSE
AUTO TAPE SELECT/HIGH SPEED DUBBING
Deck B).
AUTO REVERSE
AUTO TAPE SELECT/HIGH SPEED DUBBING
) button u to start the recording.
Indicator will light during recording.
REC
) button o. Press
) button i.
indicator lights,
REC
REC button are pressed at the same time,