Automatic Tape Selection; Playback - Marantz SD4050 Mode D'emploi

AUTOMATIC TAPE SELECTION

This Stereo Cassette Deck contains an automatic tape selector which
automatically selects the optimum bias and equalization for the tape
in use. This is accomplished by detection of tape type detection holes
in the cassette housing.

PLAYBACK

¼ The operations described below apply to deck A and deck B alike.
¼ Switch on your amplifier or receiver.
¼ Set the Function Selector on your amplifier or receiver to the TAPE or Tape monitor position.
¼ The numbers in the illustration below depict the order in which operation steps are carried out.
r
DOLBY NR
C
B
OFF
TIMER
REC
OFF
PLAY
REV. MODE
AUTO TAPE SELECT/HIGH SPEED DUBBING
CCONT. PLAY
POWER ON/OFF
t q
1. Press the POWER switch q to the ON (
) button w to open the cassette compartment
2. Press the EJECT (
cover e.
3. Load the cassette tape and close the cassette compartment cover
e.
4. When listening to a tape that has been recorded with Dolby noise
reduction, set the DOLBY NR switch r to match the system used
at the time of recording.
DOLBY NR
C
B
OFF
5. Select the type of tape transport with the REV MODE switch t.
REV. MODE
Mode
To listen to one side only
To listen to playback of both sides
To listen to continuous play back
of both sides and both decks.
All manuals and user guides at all-guides.com
e
DOUBLE CASSETTE DECK SD4050
COUNTER
RESET
DUBBING SPEED
SYNC REV NORMAL HIGH
AUTO REVERSE
STOP PLAY
EJECT
A
PLAY
u w y
) position.
Switch position
¼ If a tape without tape type detection holes is used, the deck
will be set for normal tapes.
COUNTER
RESET
REC LEVEL
RECORD PAUSE REC MUTE
STOP PLAY
AUTO TAPE SELECT/HIGH SPEED DUBBING
MIN MAX
PHONES
EJECT
B
PITCH
REC/PLAY
CONTROL – +
6. Press the PLAY button y (
Transport Direction
Forward
Reverse
) button u to stop the playback.
7. Press the STOP (
¼ In the continuous playback mode (REV MODE set to
playback of both tape sides will be repeated 5 times and then
stop automatically.
¼ If different types of Dolby noise reduction are used for record
and playback, playback response will be adversely effected.
¼ When power is turned off during tape transport, it may not be
possible to remove the cassette by pressing the EJECT (
button. In this case, turn on power again before you press the
EJECT ( )button.
8
Detection holes
for metal tape
Detection holes for
chrome tape
AUTO REVERSE
or ) to being playback.
Indicator
),
)