Guardian IC-5307 Mode D'emploi page 11

A s s e m b l y
Assembling the Bed Ends
NOTE–
The headboard is taller than the footboard.
1. Stand the headboard next to the head section of the bed.
2. Lift the head end and engage the pins in the frame into the hooks on the headboard
(Figure 36). Leaning the headboard back slightly will help the pins fit into the
hooks more easily.
3. Lift the foot section of the bed and engage the pins on the frame into the hooks on
the footboard in the same manner.
Make sure head and foot ends are securely locked to the head and foot boards
before using bed.
Installing the Casters
NOTE–
For maximum locking stability, assemble the two locking casters diagonally at
opposite ends of the bed.
Install all four casters simply by raising the bed ends from the floor and pushing the stem
up into the caster socket in each bed leg (Figure 37).
Assembling Hi/Lo Connecting Rod
NOTE–
The connecting rod has two sections: The inner rod has a detent button, and the
outer rod has two positioning holes and one storage position hole.
1. Remove plastic caps from both ends of connecting rod.
2. Depress detent button on inner rod and insert into outer rod. Slide the inner rod in
place and engage the detent button into the middle positioning hole.
3. Connect one end of the hi/lo connecting rod to head end gearbox (Figure 38).
Connect the other end to the hi/lo motor output shaft (Figure 39). Connect the foot
end gearbox output shaft to the hi/lo motor output shaft spring-loaded connector
(Figures 40 & 41).
4. Release the hi/lo connecting rod spring-loaded connector by pushing it in and turn-
ing it clockwise.
POSSIBLE INJURY OR DAMAGE. After the bed has been assembled, check to make
sure that all components are secured properly in place and all fasteners are tight
before use.
POSSIBLE INJURY. Do not leave electric bed plugged in while not in use.
Installing the Pendant
For electric models only: Install the hand pendant by plugging its connector into the
matching socket in the control box.
NOTE–
All full-electric beds use a six-function pendant for all bed operation.
Leveling the Bed
Plug bed power cord into electric outlet. Press and hold pendant's "BED UP" button until
hi/lo motor stops automatically (see Full-Electric Bed Operation). Then, press and hold pen-
dant's "BED DOWN" button until hi/lo motor stops. Bed will be level and adjusted to its
lowest and safest position.
NOTE–
If you are having difficulty leveling the bed because only one bed end moves up or
down, check to be sure all center drive tube pins and slots are properly engaged.
POSSIBLE INJURY. Do not leave electric bed plugged in while not in use.
WARNING
WARNING
WARNING
WARNING
E n g l i s h
11
34
35
36
37
38
39