Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
11. INSTALL THE BLOWER (INTERIOR BLOWER)
Install screws into the location as shown in the pictures below (single blower or dual blower). Do not tighten screws
down fully, leave a 1/8" gap. Hang blower unit onto blower plate (screws through the large part of the keyhole). Slide
the blower to its position (screws in the small part of the keyhole). Tighten the screws.
HD0044
Single blower (P5)
Secure the blower by installing 2 more screws into the locations shown in the pictures below (single blower or dual
blower). Reinstall impeller(s) and cover.
HD0080
Single blower (P5)
FOR DUAL BLOWER UNIT, MAKE
SURE
THE
IMPELLERS
CORRECTLY INSTALLED, THE HOOD
WILL NOT WORK PROPERLY IF
REVERSED. Both impellers are different
in the dual blower, one rotates clockwise
and the other counterclockwise. Each
wheel and motor have an arrow and a
number on them, you have to match
them correctly (see drawing beside).
Never plug the 2-prong blower cord to the 3-prong power supply cord.
Plug the power supply to the 3-prong male connector (A) and
the blower unit into the 2-prong female receptacle (B) inside the
hood.
All manuals and user guides at all-guides.com
ARE
HD0023
WARNING
!
- 10 -
(CONT'D)
HD0044
Dual blower (P8)
HD0081
Dual blower (P8)
FRONT
1
A
HE0003
2
B
Publicité
Table des Matières
