Safety Cut-Out; Cleaning And Care - Klarstein STUDIO LIGHT & FIRE 1 Mode D'emploi

SAFETY CUT-OUT

This appliance is fitted with a safety cut-off which will operate if the fireplace overheats
(e.g. due to blocked air vents). For safety reasons, the fire will NOT automatically reset.
To reset the appliance, disconnect the appliance from the mains supply for at least
15 minutes. Reconnect to the mains supply and switch on the appliance.

CLEANING AND CARE

Note: Turn off the unit and unplug it from the power outlet. Wait until the unit has
completely cooled down before cleaning it.
• Use a vacuum cleaner to clean the ventilation slots and grilles.
• Remove dust on the outside surfaces with a damp (not wet) cloth.
• Do not use strong cleaning agents or abrasives.
• Do not allow water or other liquids to run into the interior of the product. Do not
spray the device with liquids or immerse it in water or other liquids.
• Never open the heater housing.
Storage
Keep the unit in a dust-free place during the low season. Pack it in the original carton.
Wind the heater cable cleanly to avoid damaging the cable.
EN
33