Operation Of The Chlorinator; Using The Keypad; Presentation Of Your Chlorinator's Menus - AQUALUX 103648 Notice D'installation Et D'entretien

6. Operation of the chlorinator

The DYNAMIC chlorinator is a reverse polarity electronic chlorine generator. It is made of a control unit and a production
cell. The pool must contain 3.5g/l of salt. Salt molecules are transformed into chlorine when passing through the cell. This
process is called electrolysis. The chlorine's strong oxidising properties allow disinfecting the pool. At the end of the cycle,
this chlorine is transformed back into salt. In enclosed premises, there would be no need to add any salt but some of it is
eliminated by splashes and filter cleaning processes.
DYNAMIC chlorinators work with a reverse polarity on the cell's terminals.
The duration of the reversal cycle can be set up gradually by steps of 30mn from 2 hours up to 24 hours.
The choice of this cycle's hardness is linked to the hardness of the water in the pool to be processed.
The below chart allows to select the reversal cycle's hardness depending on the hardness of the water measured.
TH (ppm)
TH (° F)
TIP (heures)
In case of an absence of self pH regulation, select the lower value.
It is preferable to process you pool's water for a TH beyond 40°F. For this, use some TH minus.

6.1Using the keypad

MENU : press this button to open the chlorinator settings menu.
UP and DOWN: Use these buttons to navigate in the-sub menus and sections and increase or decrease the values
of the settings.
OK : Use this button to confirm a change of setting of your chlorinator and to come back to the previous menu.
Use the CANCEL button to cancel a setting and exit the menus.
Use this button to activate the « BOOSTER » function.
This function activates a 100% functionning for 24 hours. This is a preventive action to do before stormy conditions or
overcrowding (weekend). It can not substitute for a shock treatment or other chemical treatment in the case of water unfit
for swimming (cloudy water, algae, ...)

6.2 Presentation of your chlorinator's menus

The menus provide easy access to all the settings of your DYNAMIC chlorinator.
The 32 characters back-lit screen displays explicit messages allowing a very easy programming of your chlorinator for optimal
performances.
Your chlorinator's menu is organised as follows :
The permanent display alternately shows
NOTESD - IND B – 02/2012
All manuals and user guides at all-guides.com
0 50
0 5
24 18
and if calibration is in progress
24 / 52
120 200
12 20
12 6
400
40
3