Network Connection - sylvac D300S V2 Manuel D'utilisation

All manuals and user guides at all-guides.com
#xx#PRE+xxx.xxx
#xx#PRE
#xx#TOL?
#xx#TOLabc
(a = Nominal value)
(b = lower tolerance)
(c = upper tolerance)
#xx#CLA?
#xx#CLAx
(x = 1 to 8)
All retro-commands must end by a carriage return « CR »

Network connection

It is possible to connect to the D300S through the network and collect certain
ftp client to connect. The procedure is described below:
Open the work station, right click and
select "open a network location".
Click "next".
Select "add a personalised network lo-
cation", then "next".
Enter "ftp://xxx.xxx.xxx.xxx/.
xxx.xxx.xxx.xxx represents the IP ad-
dress for the D300S. To recover this ad-
dress, check that the D300S is correctly
connected to the company network and
got to the "setting
rameters
menu.
Remark: the PC and D300S must be connected to the same network.
Check the "open an anonymous session" box.
Enter a name for the network short cut. The D300S will appear under this name
in the work station.
Loads the recorded Preset value
Returns the recorded tolerance values
Enters the values with their sign.
red for channel 6 :
Nominal value
Lower tolerance value = -0.5
Upper tolerance value = +0.5
Returns the amount of classes used
8 classes maximum can be introduced.
general pa-
Network connection"
26
= +1.0
-