Logitech io Manuel De L'utilisateur page 17

Use the following instructions to reset the pen:
1. Take off the pen cap.
2. Reset the pen by pressing the reset button with a paper clip or pencil tip. You will not
lose any information in the pen.
If the pen is still frozen after performing a reset, you can perform a master reset to restore
the pen to the factory settings. Use this procedure only as a last resort because
you will lose all the information in the pen's memory. To perform a master reset,
do the following:
1. Take off the pen cap.
2. Press the pen tip on a surface while you press the reset button with a paper clip
or pencil tip.
3. Continue pressing the pen to the surface while you remove the paper clip or pencil tip
from the reset button. Hold the pen to the surface until the Battery and Memory Status
LEDs stop blinking red, and then lift the pen. The pen restarts and vibrates to indicate
that it can be used again.
4. Insert the pen into the cradle. This allows the pen to upload the paper definition files
it had before you reset the pen.
English — Logitech io Personal Digital Pen
13