Logitech io Manuel De L'utilisateur page 13

8 8
Recharging the Logitech io
You can use the Logitech io for up to 25 pages before the battery needs recharging.
When the battery status LED turns red, the pen battery is low, and when this LED
flashes red, the pen is about to run out of battery power.
Recharge the pen immediately by removing the cap and inserting the pen into the cradle.
Connect the cradle to the computer. (See "Connect and Charge the Logitech io" in
this manual for more information.)
While the pen is charging, the Battery Status LED will slowly flash yellow, and it will turn solid
green when the pen is done charging. If the battery is completely empty, it may take up
to ten minutes before the LED flashes to indicate that the pen is charging. Refer to the table
below for more information about the Battery Status LED:
Color of LED
Green
Yellow
Red
Blinking Red
After the pen has been fully recharged, remove it from the cradle. Or disconnect
the USB cable from the computer, or remove the AC power cable from the USB connector.
Charging the pen continuously may "age" the battery unnecessarily.
Warning Use only the supplied AC adapter to charge the pen. Using another
manufacturer's AC adapter may damage the pen.
Battery Level
Battery has full charge. Stop charging the pen.
Battery is less than 50% charged.
Battery is low. Recharge now.
Battery level is critically low. You must recharge now.
English — Logitech io Personal Digital Pen
9