Gram KS Monolit Mode D'emploi page 35

GB
to alternating current. The connection
values for voltage (V) and frequency (Hz)
are given on the nameplate in the cabinet
. Power must be connected via a wall
3
socket with a switch. The wall socket sho-
uld be easily accessible.
All earthing requirements stipulated by the
local electricity authorities must be observ-
ed. The refrigerator plug and wall socket
should then give the correct earthing. If in
doubt, contact your supplier or authorised
electrician.
WARNING
The flexible cord (mains lead) fitted to this
appliance has three cores for use with a 3-
pin 13-Amp or 3-pin 15-Amp plug. If a B.S.
1363 (13-Amp) fused plug is used, it
should be fitted with a 13-Amp fuse.
IMPORTANT
The wires in this mains lead are coloured
in accordance with the following code:
GREEN-AND-YELLOW: EARTH
BLUE: NEUTRAL
BROWN: LIVE
The colours of the wires in the mains lead
of this appliance might not correspond with
the colour markings identifying the termi-
nals in your plug.
Proceed as follows:
Connect the GREEN-AND-YELLOW wire
to the plug terminal marked "E" or an earth
symbol, or coloured GREEN, or
GREEN-AND-YELLOW. Connect the
BLUE wire to the plug terminal marked "N"
or coloured BLACK.
Connect the BROWN wire to the plug ter-
minal marked "L" or coloured RED.
You can change the
door from right-hinged
to left-hinged or vice
versa yourself
Illustration shows how easy it is to
4
All manuals and user guides at all-guides.com
change the door from right-hinged to left-
hinged - or vice versa.
Lay the refrigerator on its back, front
uppermost. First, using a 2.5 mm hexagon
key, remove the handle
front legs
This also releases the lower hinge.
Transfer top and bottom hinges to the
opposite side.
Bottom hinge:
Using a 13 mm open-ended spanner and a
2 mm hexagon key, move hinge pin and
grubscrew to opposite hand.
Top hinge:
Move hinge pin
that the pin must be mounted opposite
hand when it is moved to the opposite
side, i.e. it must be turned 1/4 turn.
It might be necessary to use pliers when
pulling the hinge pin free from the top.
Move the cover plug on the top of the door
4
When the door has been mounted, a 9 mm
filler (wood or something similar) should be
used at the bottom hinge. Place it between
the cabinet front and the door edge to pro-
vide suitable clearance for the sealing
strip.
Remember to place the correct number of
washers beneath the bottom hinge to en-
sure that the door has the correct height.
Fit the hinge under the leg.
When the door has been adjusted, screw
the leg in firmly and lock the hinge by
tightening the grubscrew against the cabi-
net.
Refit the door handle.
Starting up
If during transport the refrigerator has
been laid down, or if it has been stored in
cold surroundings (colder than +5°C) it
must be allowed to stabilise for at least 1
hour before being switched on.
1
using an 8 mm hexagon key.
2
to opposite side. Note
3
to the opposite side.
. Remove the
35