Quick Setup; Back-Up Batteries - Technoline WS6825 Mode D'emploi

ENVIRONMENTAL RECEPTION EFFECTS
The weather station obtains the accurate time with wireless technology. Same as all wireless devices,
the reception is maybe affected by the following circumstances:
Long transmitting distance
Nearby mountains and valleys
Among tall buildings
Near freeway, railway, airports, high voltage cable etc.
Near construction site
Inside concrete buildings
Near electrical appliances (computers, TV's, etc)
Inside moving vehicles
Near metallic structures
Place the station at a location with optimal signal, i.e. close to a window and away from metal surfaces
or electrical appliances.

QUICK SETUP

Step 1 Keep the station and outdoor sensor next to each other. Slide open the battery cover at the
back of the outdoor sensor. Make sure the channel selector is set at position 1 (top position), then
insert 2 x AAA batteries (not included) into the outdoor sensor by observing the correct "+/-" polarity
signs inside the battery compartment. Replace the battery door.
Step 2 Insert the AC/DC adaptor to any 230V AC household outlet. Then insert the DC jack to the
back case of the station. Insert the stand to the bottom of the weather station.
Step 3 Slide open the battery cover at the back of the station, then insert 1 x CR2032 Lithium battery
(not included) to the battery compartment. Make sure "+" polarity of the battery is facing up. Then
replace the battery cover.
Step 4 Peel off the protective label on the front. The weather station is ready to work for you.
The station will receive data signal from the outdoor sensor in few seconds. Then place the outdoor
sensor in a dry and shaded area outdoor.

BACK-UP BATTERIES

When the power supply is not in use, the station will be powered by the back-up batteries. The LED
display is turned off, but time and alarm time remain stored (also in the event of a power failure).
DCF SIGNAL RECEPTION AND SIGNAL INDICATOR
After the station is powered up, it starts to receive DCF signal. The
Receiving DCF signal
Successful reception
Failed reception
During reception, press the
When strong DCF signal is detected, display shows with 3 bars
When weak or no DCF signal is detected, display shows
( icon flashing)
( icon becomes static)
( icon disappear)
/ WAVE button will display reception mode and signal strength indication:
icon flashes.
.
or .