Time Setting; Alarm Setting; Dimmer Function - Technoline WS6825 Mode D'emploi

TIME SETTING

1. Press and hold the SET button for 2 seconds, hour digits flash. Press the
set the hours.
2. Then pressthe SET button again, the minute digits flash. Press the
3. Then press the SET button again, display shows 05 and flash. Press the
set snooze duration from 5 minutes to 60 minutes.
4. Then press the SET button again, display shows 00 and flash. Press the
set the time zone:
"-01" GMT +0 (United Kingdom)
"00" GMT +1 (Central Europaen time)
"01" GMT +2 (Eastern Europaen time)
Note: Time zone can only set when the clock successfully receives a radio signal.
5. Press the SET button again to store the settings and return to normal time display. The clock
will return to normal mode in around 10 seconds if no further press of any other buttons.
Note: The time is displayed in 24-hour display format.

ALARM SETTING

(default alarm setting is 6:00 AM)
1. Press and hold the ALM button until the AL icon appears on the display, the hour digits flash.
Press the or the
2. Press the ALM button again, the minute digits flash. Press the
desired alarm minutes.
3. Press the ALM button again to store the alarm settings and return to normal time display. The
clock will return to normal mode in around 10 seconds if no further press of any other buttons.
To turn on or off the alarm
Single press the ALM button during normal time display to turn on or off the alarm. When the alarm
function is turned on the AL icon appears on top of the time digits.
Note: Alarm duration is 2 minutes.
To use the snooze function
When time reaches the set alarm time, the station will give a beep sound to wake you up. The AL
icon will flash.
1. Press SNOOZE once to stop the alarm temporarily, AL icon keeps flashing. The alarm will
beep again after the set snooze duration.
2. To stop the daily alarm, press any button except the SNOOZE button when alarm is beeping.
The alarm will stop and AL icon becomes static. The Alarm will beep again same time next day.

DIMMER FUNCTION

Press the SNOOZE / DIMMER button to adjust high or low brightness of the LED display.
TROUBLE SHOOTING
In case the station shows false digits, it maybe affected by electrostatic discharge or interferences
from other devices. Press the RESET button on the back of the station. The station will be reset to
default setting of time and calendar and it will start to receive radio controlled time signal again.
button to set the desired alarm hours.
or the
or the button to set the minutes.
or the
or the
or the button to set the
button to
button to
button to