mundoclima WIFI WF-60A1 Manuel D'installation Et L'utilisauter page 43

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 69
4. INSTALLATION METHOD
3.Wiring figure
On the MUCSR and MUSTR equipment, connect the Smart Port to the
CN40 connector of the unit. inside through the 'Connective wire (4)'
(Possibility to extend the wire up to 6m with
the optional CL97247)
On the MUCR units, disconnect the aerial
connector of the wire (1) that is connected
to the connector CN40 of the main board
of the indoor unit (marked with an arrow)
(see Fig. 4-3)
To use the Smart Port and the wall control at the same time, make the
connection according to the following diagram (see Fig. 4-4)
Attention: It is necessary to open the rear and front panel of the Smart Port
HB
HA
WIRED CONTROLLER
KJR-120G/TF-E
AU-KJR-120G/TF-E
Note: Designation of the connection cables
(1) 4-wire cable connected to main board CN40, supplied with indoor unit.
(2) 4-wire cable connected to the CN2 of the convert board, supplied with the indoor unit.
(3) 4-wire cable connected to the CN2 of the Smart Port, supplied with the Smart Port.
(4) 4-wire cable connected to the CN3 of the Smart Port, supplied with the Smart Port.
(5) 2-wire cable between adaptor board and wall wiring controller, not supplied.
4
(2)
CN2
CN8
CONVERT
(5)
HB
BOARD
HA
CN8
4
(1)
4
4
(4)
(3)
CN3
CN2
SMART PORT
43
Disconnect
4
CN40
(1)
4
(2)
INDOOR UNIT
MAINBOARD
CN2
CONVERT
HB
BOARD
HA
CN40
INDOOR UNIT MAINBOARD
Fig 4-3
Fig 4-4

Publicité

Table des Matières
loading

Table des Matières